Appliance
Maytag microwaves
235 pages and 76 code pages, and they are not spread evenly: 67 of them belong to the over-the-range machine and 9 to the countertop one. That matches what these appliances actually are. An over-the-range microwave is also the kitchen's hood — it carries a fan, a damper, a light and a duct — so it fails in ways a countertop machine cannot, and this make documents it accordingly. There is no built-in microwave in this catalog: that branch belongs to a sister brand, and on that sister's own base every page of it now answers 404.
- 1 symptoms we are called out to
- From $89 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
The short version
What this equipment is, for a repair
Configurations
Over-the-range and countertop · no built-in in this catalog
Access
Planned before the visit, not discovered on arrival
Parts
OEM, available on order
Diagnostic
From $89, credited to the repair
What goes wrong with it
Symptoms we are called out to on Maytag microwaves
Each one covers the likely causes in the order they are worth checking, and what to do in five minutes before booking anything.
-
The turntable spins, the light is on, and the food is cold Microwave runs but does not heat
A microwave that runs without heating is the one appliance on this site where the honest advice is often not to repair it. The part that makes the heat sits behind a capacitor that holds a dangerous charge long after the plug comes out, and on a countertop machine the repair rarely makes sense against the price of a new one. Over-the-range units are a different conversation entirely.
- Everything running normally except the heat is the classic picture and it is specific
- Never open the case — the capacitor holds a charge with the machine unplugged
- An over-the-range unit is built into cabinetry and is usually worth repairing
What we do on it
Repairs we carry out on Maytag microwaves
Starting figures for this equipment in South Florida. The exact cost is confirmed after an on-site diagnostic — and this is not the whole list of what can go wrong, so call if your problem is not here.
-
from $89 Diagnostic visit
We find out what is wrong before anybody quotes a part, and on this make that means two different visits depending on which half of the kitchen we are in. A washer or an oven will usually be showing something, and the first ten minutes are spent reading it. A refrigerator or a freezer will be showing nothing at all, because this maker publishes almost no codes for cold, and those minutes go on thermometers instead. The fee comes off the bill when you go ahead with the work.
- Read first where the machine talks, measure first where it does not
- Age is established early: these machines are routinely older than the kitchen
- Credited toward the repair
-
from $119 Appliance maintenance
The visit that stops the other visits, and on equipment bought to last it is the one that pays for itself twice over. The list is short and specific: the condenser at floor level in a humid kitchen, the dryer duct that gets longer every year in effect if not in fact, the seals this climate works harder than the manual assumed, and the drain that must not stand. None of the four announces itself, and all four are cheaper to keep than to repair.
- Condenser, seals, drains, vents and leveling, on every appliance in the run
- The intervals are set to this climate rather than to the manual's calendar
- You keep a written note of what is aging and roughly when it will matter
-
from $139 Appliance installation
Fitted against the maker's own figures rather than pushed into a hole and switched on. There is a published cutout, a required clearance, an anti-tip fixing and a water connection, and equipment installed to those figures gives years of quiet service. Installed without them, it generates precisely the calls the rest of this site describes: doors that will not seal, coils with nowhere to breathe, laundry that never comes out dry.
- Cutout, clearance and anti-tip against the maker's published figures
- The dryer duct is inspected and measured at installation, not after the first complaint
- Run under load before we leave, not plugged in and left
-
from $265 Appliance control board repair
Everybody reaches for this part first, and the manufacturer's own documentation asks that it be proved innocent before it comes out. One control architecture runs across this whole corporation, which is why a letter-and-number on a range looks so much like one on a washer — and why a board diagnosed by resemblance rather than by measurement gets replaced perfectly well and changes nothing. Boards seldom die of nothing, and whatever killed this one is still in the appliance when the new one goes in.
- Proved before it is condemned: supply, harness and the connections into it
- A browned connector or a pin backed out of its housing is cheap; a board is not
- Programmed to your model afterwards, or the appliance behaves oddly in ways nobody links back
-
from $165 Microwave repair
Sixty-seven of this maker's seventy-six microwave code pages belong to the over-the-range machine, which is the one worth repairing. It is fitted, wired, often ducted, and it carries the ventilation for the range beneath it — so replacing one is a carpentry job on top of an appliance one and the repair usually wins. On a countertop machine the arithmetic runs the other way and we say so on the phone rather than after a visit.
- Over-the-range machines: fitted, ducted, and the hood as well
- On a countertop machine we will usually tell you not to bother
- The high-voltage side is the last thing opened, not the first
-
from $145 Over-the-range microwave vent service
On most Maytag kitchens this appliance is the hood, which is why it gets a row of its own. Blower, damper, grease filters and — on a recirculating installation — the charcoal filter that nobody is told is a consumable. Most of the calls that arrive as smoke in the kitchen are about this half of the machine rather than the cooking half, and most of them are cheaper than the owner expects.
- This is the hood on most kitchens with this badge in them
- Grease filters and the charcoal filter first — both are consumables
- A fan that starts by itself is usually the appliance working correctly
In more detail
About Maytag microwaves
An over-the-range microwave is two appliances
It cooks, and it is the ventilation over the range. That second job is the one that ages it: grease filters that need washing more often than anybody washes them, a damper that has to open against whatever the duct is doing, a fan motor running above a heat source, and on a recirculating installation no outside duct at all. Most of the calls we take about these are about the hood half, and most of them are cheaper than the owner expects.
Where the honest answer is a new machine
A countertop microwave that has lost its high-voltage side is rarely worth repairing, and we say so on the phone rather than after a visit. What changes the arithmetic is being built in: an over-the-range machine is fitted to a cabinet, wired, sometimes ducted, and carries the hood for the range below it. Replacing one is a morning's work before the appliance is even unpacked, and that is what usually makes the repair the sensible side of the line.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Maytag microwaves
It runs but does not heat.
The one repair on this site we will sometimes talk you out of. The high-voltage side of a microwave — magnetron, diode, capacitor — is genuinely dangerous to anyone without the right equipment, and on a countertop machine the parts and the labor together are frequently more than the appliance is worth. On an over-the-range machine the arithmetic is the opposite: it is fitted, it is the hood as well, and replacing it is a carpentry job on top of an appliance one, so the repair usually wins.
The fan runs on its own, or will not run at all.
That is the hood half of the appliance rather than the microwave half. An over-the-range machine has a thermostat that starts the fan when the range beneath it gets hot — so a fan that starts by itself is often the appliance protecting itself correctly. A fan that will not run is the motor, the damper or the control, and it is worth mentioning that the grease filters above a range in daily use are the first thing to check and the cheapest.
There is a code on the display.
Photograph it. Over-the-range machines account for 67 of this make's 76 microwave code pages, and the number will usually point at the touch panel, the door interlocks or the thermostat rather than at the high-voltage side. That distinction decides whether this is a modest repair or the conversation about replacement.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name